In two of my previous post, there has been a dire need to perform a decoder to decoder firmware transfer in other to either revive your dead fake strong decoder, or to revive your expired liberty decoder.
Or if your case is that of a dead fake / counterfeit strong decoder, then you can still wake it up by following the same tutorial.
Like i said earlier, it may get to a point when a decoder to decoder firmware transfer will be inevitable. most especially in the two above mentioned case, where you can either not upgrade your fake strong decoder via rs232 or you cannot find a loader for your liberty decoder. Due to popular demand by (mostly novice) on how to transfer the firmware of on strong decoder to another strong decoder of the same model. E.g the two strong the coder must be the same model that . if it is strong 4669x then the two decoders must both be strong 4669x annd they must also be both fake decoders of which one is working and the other one dead. Please do not transfer firmwares between two different strong products.
As for liberty decoders, the same rules that applies to strong decoders above, also applies to it. so please don’t try to transfer the firmware of a working liberty decoder to an expired liberty decoder of different models. e.g don’t transfer t1 firmware to t3 decoder.
STEPS TO DO THE DECODER TO DECODER TRANSFER:
The steps is basically for strong, but you can apply it for liberty as well
1. You need to get a rs232 cable
2. Get another working decoder of that same type
3.connect the two decoder via rs232 and remember to switch off the fried / expired one
4. Switch on the good one. Go to – system setting – data transfer – firmware – ok.
Wait till it finish loading. That’s all.